Select your currency
Select your currency
The MicroTec range of test and measurement probes are suitable for use with oscilloscopes, multimeters and other test equipment.
This high quality, general purpose oscilloscope probe has a 60 MHz bandwidth. A two position slide switch allows attenuation of either x1 or x10 to be selected.
The TA132 is a 150 MHz low-cost, general-purpose passive high-impedance oscilloscope probe designed for use with oscilloscopes. It is calibrated to work effectively with instruments that have an input impedance of 1 MΩ. A two-position slide switch on the probe handle allows the attenuation ratio to be switched between 10:1 and 1:1. The small box adjacent to the BNC plug contains two adjustable resistors that enable high-frequency trimming.
The probe is equipped with a basic accessory pack including a retractable hook tip, compensation adjustment tool, IC insulation cap, insulating cap, a ground spring, BNC adapter and a ground lead.
This passive high–impedance scope probe has a 250 MHz bandwidth and high–frequency trimming. A two position slide switch allows attenuation of either x1 or x10 to be selected.
The TA150 is a high-impedance passive probe with 350 MHz bandwidth. It is designed for use with oscilloscopes with a 1 MΩ input impedance and has a fixed attenuation of 10:1. The TA150 has been compensated to ensure optimal performance with the PicoScope 6402 and 6403 oscilloscopes.
The TA133 is a high-impedance passive probe with 500 MHz bandwidth. It is designed for use with oscilloscopes with a 1 MΩ input impedance and has a fixed attenuation of 10:1. The TA133 has been compensated to ensure optimal performance with the PicoScope 6404 oscilloscopes.
The PP359 is a pack of replacement accessories for the PicoScope 2104 and 2105 oscilloscopes. The accessory pack contains the following items:
The ADF25A is an active differential oscilloscope probe. The probe permits the measurement of signals which are not referenced to earth using a conventional earthed oscilloscope. This enables mains voltages to be tested. It is possible to measure and observe the waveforms of three phase supplies or the gate / control signals of semiconductor circuits. It is ideal for investigation of motor speed controls, uninterruptible power supplies, switch mode power supplies and process controllers.